- Bohrungsdurchmesser
- 0.4995 inches minimum and 0.5000 inches maximum
- Abstand Bohrungsmitte bis Schaftende
- 3.3020 inches minimum and 3.3220 inches maximum
- Härtegrad
- 36.0 rockwell c minimum and 39.0 rockwell c maximum rod end body
- Innere Elementbreite
- 0.9350 inches minimum and 0.9370 inches maximum
- Gesamtlänge
- 4.1970 inches minimum and 4.2270 inches maximum
- Materialdokument und Klassifizierung
- ams 5610 assn std single material response race insert
- Materialdokument und Klassifizierung
- ams 5643 assn std single material response rod end body
- Materialdokument und Klassifizierung
- qq-s-763 fed spec single material response inner layer
- Material
- plastic tetrafluoroethylene race liner
- Material
- steel comp 416se race insert
- Material
- steel comp 440c inner layer
- Material
- steel comp 630 rod end body
- Außendurchmesser des äußeren Elements
- 1.7900 inches minimum and 1.8100 inches maximum
- Breite des äußeren Elements
- 0.6250 inches minimum and 0.6350 inches maximum
- Schaftgewindelänge
- 1.9900 inches minimum and 2.0300 inches maximum
- Schaftausführung
- externally threaded
- Besondere Merkmale
- keyway in shank,0.125 in. min 0.130 max w,0.0835 in. min 0.0845 in. max deep; 4 punch locks per side located on 1.570 in. dia on face of rod end body
- Stilbezeichnung
- ball type
- Testdatendokument
- "81349-mil-i-6866 specification (includes engineering type bulletins, brochures,etc., that reflect specification type data in specification format; excludes commercial catalogs, industry directories, and similar trade publications, reflecting general type data on certain environmental and performance requirements and test conditions that are shown as "typical", "average", "nominal", etc.)."
- Thread-Klasse
- 3a
- Gewindedurchmesser
- 0.562 inches nominal
- Gewinderichtung
- right-hand
- Gewindeanzahl pro Zoll
- 18
- Gewindeserienbezeichnung
- unf
